Elite Screens Manual Series User Manual download pdf (Page 6)

Vertical Limit Switch Adjustment

Caution:

Screen may be severely damaged if viewing surface is allowed to run too far UP/DOWN.

Back Of Screen

Up Vertical Position

Down Vertical Position

Your screen has been set to drop all the way down and to rise all the way up. However, in the

event that your screen does not please use the instructions below to adjust the drop/rise to the

desired position.

Note: You will require a 5/32” allen-wrench to perform the adjustments below

“UP” Vertical Position Adjustment

1. Insert the allen-wrench into the top keyhole, turning the allen-wrench clockwise will

allow the screen to retract to it’s original position.

Note to self: You will not notice a difference of this adjustment until you press the DOWN button

then up to see the differences.

2. Turning the allen wrench half a circle counterclockwise will cause the screen to stop further

out of the screen’s case.

“DOWN” Vertical Position Adjustment

1. Insert the allen-wrench into the bottom keyhole, turning the allen-wrench one full

circle counterclockwise to limit the black masking border level.

Note to self: Only if screen does not extend to desired position.

2. Turning the allen-wrench one full circle clockwise will allow the screen to drop down

the black masking border.

3. Turning the allen-wrench one full circle clockwise will allow the screen to drop down

the black masking border.

Rev 1.2

1 2 3 4 5 6 7 8

No comments

Elite Screens Manual Series User Manual Page 6