Elite Screens Manual Series User's Guide download pdf (Page 4)

Rev 1.3

Examples Of Installation & End Cap Dimensions Page

Cealing Chain

Mounting

Cealing Flush

Mounting

Flush wall

Mounting

Cealing Dry

Wall

1. Start by locating the studs on

your wall. Make sure to measure

the keyholes located on the back

end of the screens end caps.

2. Mark the area where screw hole

will be inserted for the L”

bracket or screen. The L” bracket

is sold sepperatly.

3. Setup (a) is a well example for

mounting the screen using the L:

bracket.

4. Setup (b) is another example for

mounting the Screen flushing it

against the wall.

5. Setup (c) is a hard task to

achieve and you may need to

consult with a proper installer/

contractor. Additional hardware

may be required. If flush mounted

as shown on example (c) it is wise

to have about 2” of space away

from the housing/case.

6. Setup (d) is an example of cealing

mount/chain hanging. By using a

proper chain and hooks it can be

sustained by the cealing. Locate

studs on the cealing before

mounting for proper support.

L” Bracket

Mounting

Note:

Regardless of mounting method, screen should be securely supported so that vibration on the viewing surface

will not cause case to work loose or fall. Installer must insure that fasteners used are of adequate strength and

suitable for the mounting surface chosen.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Elite Screens Manual Series User's Guide Page 4

Comments to this Manuals

Related products and manuals for Projector accessories Elite Screens Manual Series